Awntech DESTIN Bedienungsanleitung PDF herunterladen (Seite 26)

REPLACING AWNING FABRIC

• If you have a motor, turn it off.

• Manually crank the awning out to full projection

• Remove the front bar end caps

• Using the provided Allen wrench, unloosen the bullets at each end of the front bar C channel.

• Ask your helper to get on a step ladder about five feet from the wall on the non-motor/non-crank side

of the awning.

• On a ladder mildly push the front bar toward the wall. This will loosen the fabric

• Remove the fabric by pulling it straight out the C-channel on the non-crank/motor side of the awning.

You should pull out the front and back simultaneously.

• Install the new fabric by sliding the ends back into the C-channel from the same side. You may need to

push the front bar slightly toward the wall while two helpers feed the beads into the C-channel. There

is a slot in the end of the roller eye for it to slide into.

• Reinstall both bullets and tighten the Allen screws.

• Re-install the front end caps

• Retract the awning manually.

• Turn on the motor.

REPLACING THE VALANCE

• Remove the right and left front end caps (I)

• Using the provided Allen wrench, unloosen all the bullets at the ends of the fabric.

• Remove the bullets from the C-channel.

• Remove the valance by pulling on it from the right side.

• Reinstall the new valance by sliding the top bead into the same slots in the front bar (J)

• Reinstall both bullets and tighten the Allen screws.

• Reinstall the right and left front end caps (I)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 34 35

Keine Kommentare

Awntech DESTIN Bedienungsanleitung Seite 26